![]() The Tunnel-Password attribute is not defined. The tunnel password is used as the Internet Key Exchange Password that is used to authenticate the peer to a remote server. No set aggressive-mode password password Syntax Description ![]() To remove this attribute from your configuration, use the no form of this command. Use the set aggressive-mode password command in ISAKMP policy configuration mode. To specify the Tunnel-Password attribute within an Internet Security Association Key Management Protocol (ISAKMP) peer configuration, Specifies the Tunnel-Password attribute within an ISAKMP peer configuration. Set aggressive-mode client-endpoint user-fqdn aggressive-mode password cisco123 Related CommandsĮnables an IPSec peer for IKE querying of AAA for tunnel attributes in aggressive mode. The following example shows how to initiate aggressive mode using RADIUS tunnel attributes: The Tunnel-Client-Endpoint attribute will be communicated to the serverīy encoding it in the appropriate IKE identity payload. To initiate an IKE aggressive mode negotiation and specify the RADIUS Tunnel-Client-Endpoint attribute, the set aggressive-mode client-endpoint command, along with the set aggressive-mode password command, must be configured in the ISAKMP peer policy. This command was introduced on Cisco ASR 1000 Series Routers.īefore you can use this command, you must enable the crypto isakmp peer command. This command was integrated into Cisco IOS Release 12.2(33)SRA. This command was integrated into Cisco IOS Release 12.2(18)SXD. The Tunnel-Client-Endpoint attribute is not defined. The ID type is translated to the corresponding ID type in Internet Key Exchange (IKE). ID_FQDN (fully qualified domain name, for example "") One of the following identification types of the initiator end of the tunnel: No set aggressive-mode client-endpoint client-endpoint Syntax Description Set aggressive-mode client-endpoint client-endpoint ![]() To specify the Tunnel-Client-Endpoint attribute within an Internet Security Association Key Management Protocol (ISAKMP) peerĬonfiguration, use the set aggressive-mode client-endpoint command in ISAKMP policy configuration mode. Set aggressive-mode client-endpoint through show content-scan
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |